Gestation Stall
Product Features
Save space, reduce fighting, and facilitate management;
The front of the pen is high and the back is low, and the front of the grille is vertical and the back is horizontal, making it convenient for mating operations;
U-shaped rear door, upwards mounted for mating, reverse mounted for fecal cleaning, touch locker, easy to open and close;
Stainless steel long trough with large arc transition and no accumulated feed at the bottom.
1.The overall hot-dip galvanizing of the pen panel after welding, with an average zinc layer thickness of not less than 80 μ M;
2.outer frame of Φ26 pipes and an inner lining of Φ21 pipes. The bottom frame is 170mm above the ground, and the vertical grid spacing is 140-160mm. The front is dense and the back is sparse, and the horizontal grid spacing is 170mm;
3. Rear in and front out, with fence doors at the front and rear, touch switch, rear door design is convenient artificial insemination;
4. Matching feed long trough, Φ60 feed drop pipe is welded to the fence as a whole, and the bottom of the pipe is bent;
5. Each group of pens is fixed with three horizontal national Φ21 galvanized steel pipes on top, using U-shaped clamp to connect and fix the pen when installation;
6. The fixation of the foundation and the leakage plate is made of stainless steel bolts and nylon block nuts. The bolts are fixed from top to bottom without damaging the pig's feet;
7. The length and width of the pigsty are customized according to the plan, with a height of 1000mm;
8. Stainless steel long food trough, with an outer edge mouth height of 150mm and an inner edge mouth height of 105mm. The upper edge mouth width is 300mm and the bottom width is 170mm. The bottom is an R50 large arc to avoid feed accumulation;
9. Stainless steel 304, wall thickness 1.2mm, plate thickness in accordance with national standards;
10. The water outlet of the feed trough is bottom drainage, with a plug type outlet.